Hello,
i
try to run octopus(3.0.4.) with millumin2 and i could not receive any
osc commands from octopus into millumin2 activity monitor.
Octopus and millumin2 runs on different computers. Both are in the same network.
In Octopus i add a device with the ip Adresse and the port 5000 and boardcast is set off.
And the green light comes...
Then i create a preset but nothing happen. when i use octopus and playbackpro its work.
what could I have forgotten? Thanks for your help.
i
try to run octopus(3.0.4.) with millumin2 and i could not receive any
osc commands from octopus into millumin2 activity monitor.
Octopus and millumin2 runs on different computers. Both are in the same network.
In Octopus i add a device with the ip Adresse and the port 5000 and boardcast is set off.
And the green light comes...
Then i create a preset but nothing happen. when i use octopus and playbackpro its work.
what could I have forgotten? Thanks for your help.